JMRI Install Guide: Using a PDA to Access JMRI Applications

Daryl Kruse has been experimenting with a Dell Axim PDA for use as a true 2-way Digitrax throttle. He's provided the following information on how he set it up:

1. Our home has a wireless LAN set up for household members to access our cable internet service.

2. My train computer is connected to our LAN and, of course, is connected to the Loconet via an MS100 and JMRI.

3. My Dell Axim has wireless and terminal services client.

4. After staring up JMRI Throttles and turnout control, I use the the terminal services client of the Axim to access the computer screen.

5. I can then control the layout with the Axim.

I am using the Terminal Services Client that came installed on my Axim x50v which came with windows mobile 2003 SE insalled as the operating system. On the computer I check the box "allow users to connect remotely to this computer" in the control panel/systems/remote tab.

The main, four way button of the axim can be used to increase (left) and decrease (right) speed and set the direction of the train (up- forward, down-reverse). I use the blunt end of my home made uncoupling pic to address the screen in order to select and dispatch locos, operate functions and set turnouts. All this can be done without ever plugging into the loconet.

One thing that is a little bit combersome is entering the turnout numbers into the turnout control. For this I have to use the axim keyboard. I would like to use the turnout table, but every accessory switch that is used shows up automatically on the table. As I use route control, a lot of unneeded accessory switch numbers show up that I don't need. Is their anyway to set up a table that is set with just the accessory switches you want?

Here's are pictures of the axim screen and the axim itself.

---