Skip to main content

LocoNet Slot Monitor

Command Station Slot Monitor
The Slot Monitor tool displays a table of the "command station slots'" contents. Slots are used to control individual locomotives and consists. The display includes the decoder's speed step format, current speed and function settings, consist information and status. You can choose to show either all slots or just the ones being actively used.

The checkboxes at the top allow you to show just the active (in use) slots, or all locomotive slots. You can also choose whether to show the "system" slots, which don't carry locomotive information. The "Estop all" button sets the speed of all the locomotives to "Emergency Stop" very quickly.

The columns are:

Slot
The number of the slot
E Stop
Click this button to set the speed of the decoder to emergency stop
Address
The address of the locomotive the slot controls
Speed
For unconsisted locomotives and addresses that are the top of a consist, this is the current speed setting. It's an internal value for consisted slots.
Decoder Type
The format of the commands being sent to the decoder, typically either 128 step or 28 step, though other valuesa re possible.
Status
One of the four possible states:
Free
Not reserved for any particular use, no contents
Idle
Not reserved for any particular use, no contents
Common
Not in use at the moment, but still contains valid data for the last decoder to use it
In Use
Currently controlling a decoder
Free
Click this button to free the slot, so it can be reused for another locomotive
Consisted
Displays the consist status of the slot, whether it's not consisted, the top of a consist, included in a consist, etc.
Throttle ID
The ID of the throttle using this slot. It's displayed as two hexadecimal bytes. The second pair can be configured into the throttle, see the Digitrax instructions.
Direction
Whether the decoder is currently being commanded to go Forward or Reverse
F0-F8
The current function settings