Configure Digitrax BDL16x
The JMRI BDL16x programming tool lets you configure the internal options of a BDL16, BDL162, or BDL168 directly from your computer, when the board is connected to a JMRI LocoNet connection.
To open this tool select "Configure BDL16/BDL162/BDL168" from the LocoNet menu.
Selecting the BDL16x board
Each BDL16x device present on the LocoNet connection is identified by its "Board ID". This tool may access a particular BDL16x device by entering the "Board ID" number in the selection box at the upper left of the tool window.
Upon start-up, this tool queries the LocoNet connection to create a list of BDL16x devices. Each BDL16x Board ID is added to the list in the pull-down selector, accessed by selecting the downward-pointing triangle which is just to the right of the Board ID text entry space.
Any time that a Board ID number is typed into the Board ID text entry space, the number will be added to the list if it is not already present in the list.
Reading and writing the OpSw settings
This tool only accesses the board's OpSw values when the "Read Full Sheet" or "Write Full Sheet" button is pressed.
The "Read Full Sheet" button may be used to read the OpSw settings from the DS64. Performing the "Read Full Sheet" operation reads all OpSw values from the board selected by the "Board ID" field and updates each of the tool's selections.
The "Write Full Sheet" button may be used to write the OpSw settings currently shown in the tool to the BDL16x device specified by the "Board ID" number shown at the top of the window. Performing the "Write Full Sheet" operation writes all OpSw values to the board.
The configurable options
The basic operating settings are shown grouped into three sections. The top-most section shows the options which apply to all BDL16x types. Immediately below are the basic operating settings which apply only to the BDL162 and BDL168. Below this are the basic operating settings which apply only to the BDL168.
Each setting may be changed by selecting one of the values in the pull-down list of values.
When performing a "Write Full Sheet" operation to a BDL16 or BDL162 device, this tool will write all of the OpSw values, not just the OpSw values which are defined for the BDL16 or BDL162 device. This is thought to be safe, as it is thought that these OpSw values will be ignored by the hardware. If you are concerned that this may not be acceptable, then select the "default" value for the OpSw values which do not apply to the board type which you are configuring.
- This tool is not able to detect the difference between a BDL16, a BDL162, and a BDL168. As such, it always shows all OpSw values and descriptions for the BDL168, and the "Write Full Sheet" operation will write all OpSw values.
- This tool is able to access BDL16x boards with addresses between 1 and 256. Users are advised to avoid using the factory default board address (board address 1) as it will be difficult to program new boards with unique data if any in-service board is using the factory default board address.
- Because of the way the BDL16x board works, this tool can't change the basic address of the unit. The BDL16x documentation describes how to change the board address.
Documentation for the BDL16, BDL162, and BDL168 can be found at the Digitrax Web Site.